Check to make sure each box includes the following contents:

Contents: d 1 - Round Magnet 5 - Half-inch Screws 1 - Large Collar 1 - Small Collar 1 - Transmitter Unit A 1 - Receiver Unit B 3 - AA Alkaline Batteries 1 - 9-volt Akaline Battery

INSTALLATION INSTRUCTIONS

Step 1
1. Remove plastic dome on top of oil tank.	2. Take the round magnet. Remove protective cover from tape and place on top of indicator.	3. Replace dome.

Step 2
1. Using a Phillips screwdriver, remove back cover from Unit A – the Transmitter.	2. Install the 9-volt battery:	3. Replace the cover:
4. Select the collar that fits your dome	5. Attach with screws and leave loose.	6. Slide over oil gauge with bottom of Unit A.
7. Align to the top of the empty line on dome.	8. Tighten screws.	9. This is how it should look.

Step 3
1. Take the receiver - Unit B.	2. Remove the battery cover and install three AA batteries	3. We recommend that you place the receiver in your kitchen near the phone.

Installation is now complete! That’s it!
OilAlert is now on the job!
NEVER RUN OUT OF OIL AGAIN!